Our Products [Video]   Tumblast   Swing Table   Hanger   LPG Cylinder   Roll Etching Machine   Strip Cleaning Machine   Plate Cleaning Machine   Coil/Rod/Billet Cleaning Machine     Pipe Cleaning Machine   Structure Cleaning Machine   Shot Peening Machine   Stone Texturing Machine   Spare Parts   Dust Collectors   Pneumatic/Air Operated   Blast Wheel   Maintenance of Shot Blasting Machine   PARTS INQUIRY FORM   What is New in Shot Blasting   Shot Blasting in Steel Industry       Maintenance of Shot Blasting Machine   Download PDF for Maintenance of Shot Blasting Machine Typical Installation Diagram showing shot blast machine, dust collector and piping.   The Wheel (Abrasive throwing device) rotates at 2250 RPM developing velocity of approx. 245 ft/sec and the impact force delivered on the work piece through abrasive will clean the article. (Fig. A, B, C, D) The Shot blast pattern : 8 inches to the right of the vertical centerline on a clockwise wheel. The pattern is called hot spot and feel quite warm to hand if touched. Check Pattern regularly. Elevator: Elevator belt should be kept tight for and in center for proper operation. When the impeller wear exceeds abrasive will hit the back of the blade causing damage to bare wheel and blade replace the components Improper blast pattern will cause 30-40 % loss in cleaning efficiency and increase blasting time. Check blast pattern regularly. For more detail please fill out Machine Parts Form and we will contact you.